QAD Ultra Rest Hunter Not Dropping – Tips

QAD Ultra Rest Hunter Not Dropping – Tips

These are things to check if your drop away rest is not dropping. These are specific to the QAD drop away rest designs. This video is specific to the QAD Ultra Rest Hunter Model.

  1. Check your install instructions.
  2. Tension in cord – install the cord at least 3″ below the rest
  3. The launcher must be at the 90 deg. position at full draw. (Timed toward the end of the draw cycle for best clearance of vanes when the shot is fired. Adjust cord length to get this tuned for your setup.) See Video
  4. Do not use the marked lines on the rest***these are for reference only! See Video

Timing and tuning of the drop away rest is very easy with the now serving Anchor Knot distributed through Bohning.com. This is a Sawtooth Outdoor Products design and original product designed to save you time and make tuning your drop away rest easier and save time!

Bohning Products on Amazon

See other posts on drop away rest tuning.

No comments.

Leave a Reply

Your email address will not be published. Required fields are marked *